The effect of water absorption on acrylic surface properties.

PURPOSE

The aim of the present study was to determine whether an increased water content during thermal cycling of hot water-treated acrylic was associated with a reduction in surface hardness and an increased opacity or whitening of the surface.

MATERIALS AND METHODS

Ten acrylic samples were treated with 30 soak cycles (cycle duration, 24 hours), using warm water (40 degrees C) and an alkaline peroxide tablet (Efferdent control group); a further ten samples were treated with boiling water (100 degrees C) and one Efferdent tablet (experimental group). Indentation hardness of the acrylic specimens was measured prior to and immediately following the completion of the warm and hot water treatments, using an automated micro-indentation system. The hydrated acrylic specimens were then allowed to air dry at room temperature (20 degrees C) and were weighed weekly until they had obtained a constant dry weight. The loss in weight of the acrylic specimens represented the maximum water absorption.

RESULTS

The hot water-treated specimens were much whiter than the warm water-treated specimens. The mean reduction in hardness (H(IT)) of the acrylic specimens following the treatment with hot water and alkaline peroxide tablet was 12.9%. Treatment with warm water and alkaline peroxide resulted in a slight increase in mean hardness (2.63%). There was a significant correlation between the water content of the acrylic specimens after treatment and the percentage of change in indentation hardness (r= 0.495, p= 0.026).

CONCLUSIONS

The hot water treatment of the acrylic was associated with a significant reduction in hardness. We attribute the whitening and reduction in the hardness of the hot water-treated specimens to absorption of water and a disruption of the acrylic surface structure.