Evaluation of two Bis-GMA analogues as potential monomer diluents to improve the mechanical properties of light-cured composite resins.

OBJECTIVES

The aim of this study was to investigate the influence of new diluent agents, diluent ratio and filler content, on relevant mechanical properties of several novel composite resins containing Bis-GMA as resin matrices, and to compare these with the properties of composites based on TEGDMA, a conventionally used diluent.

METHODS

Two Bis-GMA analogues were synthesized and 20 experimental composite resins were prepared combining three monomer mixtures (Bis-GMA/TEGDMA, Bis-GMA/CH3 Bis-GMA and Bis-GMA/CF3 Bis-GMA), at three dilution rates (85/15, 10/90, 0/100) and three levels of hybrid filler content (barium aluminosilicate glass): 0, 10 and 35%. Flexural strength (FS), modulus of elasticity (ME) and microhardness (VHN) of the composites were evaluated. Five specimens of each material were prepared for each mechanical test, light-cured over 120 s and stored in water at 37 degrees C for 1 week. Three-point bending test was used for FS measurement and VHN was quantified by using a Vickers microindentor. Data were analyzed by ANOVA and Student-Newman-Keuls tests (P<0.05).

RESULTS

Materials with CH3 Bis-GMA showed an enhanced VHN. Mean FS was higher for matrices containing TEGDMA. Overall, dilution favored FS and VHN but not ME. Filler loading specially improved ME and VHN.

SIGNIFICANCE

Results correlate with an increase in the extent of polymerization due to the higher flexibility of the less viscous comonomer starting system and the hydrophobic character of the Bis-GMA analogues.